- Out-of-Stock
FlySky Paladin Receiver (Check Availibility)
0
reviews
Leave review
R1,150.00
Tax included
**If you are looking for larger quantities of stock than what we have listed, please contact us.**
FlySky FTr10 2.4G 10CH AFHDS 3 RC Receiver Support i-BUS/S-BUS/PPM Output Compatible PL18 for RC Drone
OVERVIEW:
FTr10 adopts AFHDS 3, Flysky's third-generation automatic frequency hopping digital system. It uses a double-antenna bidirectional transmission system and is uniquely to save space and output standard PPm i-BUS and s-bus signals.
FTr10 adopts AFHDS 3, Flysky's third-generation automatic frequency hopping digital system. It uses a double-antenna bidirectional transmission system and is uniquely to save space and output standard PPm i-BUS and s-bus signals.
Description:
Brand Name: FlySky
Item Name: FTr10 Receiver
Size: 52*28*22mm
Weight: 41g
RF: 2.4G
Protocol: AFHDS 3
Data port: i-BUS/S-BUS/PPM/PWM/URAT
RSSI:Yes
Antenna type: Dual antenna (103mm * 2)
Power input: 3.5v-18V
PWM channels: YES
Remote control distance: 10KM (open and no interference limit distance)
Update online: Yes
Temperature: -15-+60
Humidity: 20%-95%
Certification: CE, RCM, FCC ID: N4ZFTR1000
Binding:
Package Included:
1 x FTr10 Receiver
Certification: CE, RCM, FCC ID: N4ZFTR1000
Binding:
1. Insert the bind cable into the receivers bind port
2. Plug the power cable into any other port, and the receivers LED will start to flash quickly indicating that it has entered bind mode
3. Put the transmitter into bind mode; (See the transmitters instruction manual for more information)
4. Binding is successful when the receivers LED will stop flashing
Remove the power and bind cables from the receiver.
5. Reconnect the power cable to the receiver
6. Check to make sure that the transmitter and receiver are working as expected, if there are any issues or unexpected operation follow the steps above to bind again.
Attention:
Make sure the product is installed and calibrated correctly, failure to do so may result in serious injury.
Make sure the receiver's battery is disconnected before turning off the transmitter, failure to do so may lead to unintended operation or loss of control.
Make sure the receiver is mounted away from motors, electronic speed controllers or any device that emits excessive electrical noise.
Keep the receiver's antenna at least 1 cm away from conductive materials such as carbon or metal.
Do not power on the receiver during the setup process to prevent loss of control.
Note:
Ports used to connect the receiver to the various components.
SENS: Connects to sensors
SERVO: Connectsto the i-BUS module for channel expansion and output S-BUS signals.
CH1-CH10: Connects the servos, poweer supply or other components.
BIND: For bind cable
Power: Flight controller power output.
Package Included:
1 x FTr10 Receiver
FTR10-Receiver
New
